How to use an ultrasonic cleaner for your silver jewelry?

An ultrasonic cleaner quickly removes dirt, grease, and accumulated residue from links and crevices in jewelry. Here's how to effectively use an ultrasonic cleaner for your silver jewelry, while avoiding damage.

Which silver jewelry can be cleaned with ultrasound?

This method is mainly suitable for sturdy jewelry made of solid silver or 925 sterling silver, without fragile stones or glued elements. It can be used for certain necklaces, bracelets, rings, and chains.

However, avoid using ultrasound for jewelry with:

• pearls, opals, turquoise, emeralds, or porous stones;
• glued or poorly set stones;
• fragile settings;
• an intentionally blackened or oxidized finish;
• cracks or loose parts.

If in doubt, consult a jeweler.

Steps to clean your silver jewelry with ultrasound

1. Check the condition of the jewelry

Examine the clasp, links, and any stones. The jewelry must not have any loose elements, as vibrations could worsen the problem.

2. Prepare the cleaner

Fill the tank with lukewarm water, without exceeding the maximum indicated level. You can add a few drops of a neutral cleaning product compatible with silver and ultrasonic devices.

Never use bleach, solvents, or abrasive products.

3. Place jewelry in the basket

Place the jewelry in the designated basket. Avoid them touching each other to limit friction and scratches. Do not place the jewelry directly at the bottom of the tank, unless otherwise specified by the manufacturer.

4. Start a short cycle

Start with a short cycle, generally between 2 and 3 minutes. A second pass can be done if the jewelry remains dirty, but prolonged or too frequent cycles are not recommended.

5. Rinse and dry immediately

Remove the jewelry, then rinse it thoroughly with clear water. Dry them immediately with a soft, lint-free cloth. You can finish with a special silver polishing cloth to restore their shine.

Do ultrasonic cleaners remove tarnish from silver?

Ultrasonic cleaners mainly remove dirt, grease, and residue from hard-to-reach areas. They do not always completely remove tarnish caused by silver oxidation.

If the jewelry remains tarnished after cleaning, use a special silver polishing cloth or a suitable product, following its instructions. Avoid toothpaste and abrasive powders, which can scratch the surface.

A practical solution for maintaining your jewelry

The 800 ml ultrasonic cleaner allows you to clean several compatible pieces of jewelry simply and uniformly. Its tank is suitable for necklaces, chains, bracelets, rings, and other small items that can be cleaned with ultrasound.

Discover our 800 ml ultrasonic cleaner and easily maintain your silver jewelry at home.